Spec Sheet

Brochure

The Product Specification Sheet can be viewed or downloaded and printed on your printer.

The Taurus 60 Industrial Power Generator (IPG) is a compact, rugged gas turbine generator set that has been designed to meet the requirements for industrial power generation applications. The unit is provided as a completely integrated module ready for installation.

The gas turbine engine, gearbox, generator, control systems, fuel system, lubrication system, start system, and ancillary equipment needed for site operation on natural gas are included with each unit.

Each package includes a sound attenuated enclosure for the turbine generator and a power control room (PCR) building to house all generator and turbine control functions.

The Taurus 60 gas turbine engine is a single shaft axial flow engine. The output gearbox, including accessory drive pads, is a separate, close-coupled unit located at the inlet end of the turbine.

The components of the Taurus 60 engine are maintained in accurate alignment by mating flanges with plot surfaces and are bolted together to form a ridged assembly. The compressor rotor shaft drives the speed-reducing gearbox. Accessory pads drive the main lube oil pump and other accessories, depending on the application, and support the starter motor.The gas turbine output shaft is mechanically connected to both the compressor and turbine sections of the engine to form a "solid" or "single" shaft configuration. This feature enhances speed stability and response under constant and varying load conditions – a highly desirable feature in generator applications requiring precise frequently control.

The Turbotronic control system is provided and is a highly integrated programmable logic controller (PCL) based control system. The control system is installed on the package frame to minimize interconnect wiring. It  includes a microprocessor, remote communications modules; chassis based and flex input/output modules, line synchronization module, power supplies and a hardware backup shutdown system. Integrated monitoring and control of the generator is provided using a specially designed module in the PLC to receive input data from potential and current transformers. The system calculates real and reactive power, power factor and the variables required for synchronization.

ALSO INCLUDED:
Utility Grade 15KV class metal clad paralleling switchgear. Remote video display terminal to remote monitor and trend analog and discrete Data, HVAC system. Generator main circuit breaker 15KV. Auxiliary transformer, feeder circuit breaker. Bus potential transformers, feeder current transformers, metering current transformers and potential transformers, and protective relay module. Lightning arrestor and surge Capacitor. Motor control center with variable frequency drive, turbine generator battery system with charger. Dedicated switchgear battery system with charger.

An automatic synchronizer is provided with the control system to automatically synchronize the unit to the bus through push-button control on the digital control panel (DCP) or by receipt of an appropriate remote signal. A synch check relay is provided as an additional permissive and for backup protection. Raise/lower voltage push button control is provided on the digital control panel to control a motorized potentiometer for voltage control. An additional raise/lower switch, supplied by others, may be used to control voltage from a remote location. A kW import controller is provided to control the real load (kW) on the generator set while operating in parallel with a utility or other large source. The kW controller monitors the load imported from the utility source and adjust the generator set fuel flow to maintain a pre-set level of imported power on the utility at all times.

Complete accessory package including air inlet and filter system, as well as ancillary support items.

All accessories can easily be transported on flatbed trailers or in standard ISO shipping containers.

Easy shipping, both on road or via ocean transport.